Design Notebook Process

This describes the processes employed to document the engineering procedures employed to design, build, and test the robot.

Mechanical and Electrical

  • Place approved Drawing(s) (1) in Design Notebook (Responsible Student is Inspector)
  • Place Bill of Material (1 Electrical and 1 Mechanical) in respective Design Notebooks (Responsible Student is Electrical Lead and Pro E Lead)

Controls (Latest Versions)

  • Input/Output (I/O) Mapping
  • Operator Control Layout

Software (Latest Versions)

  • Flow for
  • Slow loop
  • Fast loop

Autonomous Mode

  • Algorithm
    • Drive System
    • Manipulator (Arm, Ramp, Shooter, etc.)

Back to Manufacturing Process


Page last modified on October 29, 2007, at 12:33 PM